INSTALLATION PROCESS
TOOLS NEEDED
(Use Stainless Steel blades)
OLFA KNIFE
SCRAPER BLADE
WATER BOTTLE
SOAP
(Joy, Dawn, baby shampoo)
SQUEEGEES
PAPER TOWELS
BARNISHER
When filling water bottle, add 1/2 teaspoon of Lemon Joy, Dawn, or Johnson’s Baby Shampoo.
Spray glass, razor scrape to remove dirt and particles.
Spray down, squeegee, and clean edges.
Use two pieces of tape to separate liner from the film.
Two ways to remove liner from film:
Spray liner side with solution to release static from film.
Lift the liner corner with blade tip and peel away.
Peel liner from film evenly.
DO NOT peel unevenly. It will crease the film.
Peel the rest of the liner off and soak all of the film.
Peel liner halfway, drop liner, spray top half of film.
2nd way to peel liner:
Spray glass and place film liner side up, then peel liner and flip.
Soak glass with soap solution.
With barnisher, press in edges of film.
Use window washer, squeegee film down and from middle out.
While pressing edges with barnisher, cut excess film.
Pull off excess film by pulling film out and away.
Spray film with soap solution.
Hard squeegee from center out with Blue Max squeegee.
Spray film with soap solution.
Place film on the glass surface.
1 inch from sides, push out and hold (soaking up excess water)
Double-fold Bounty paper towel over barnisher.